BISSELL STEAM SHOT SPRAYING WATER FULL

Pull both ends of the floor cloth off of the head of the mop and rinse it in water after each use. The steamer should never be stored with water in the tank. Unplug the cleaner and pour the remaining water out of the tank by removing the fill cap and dumping the water into a sink. Resume cleaning by turning the cleaner on again. Refill the water tank when the cleaner stops emitting steam by turning off the cleaner, unplugging the power cord and repeating Steps 1 and 2. Do not leave the steamer in one spot for longer than 15 seconds or it might damage the floor.

The gasket can become lodged, damaged, or removed. If the water level is adequate, check the position of the gasket on the bottom of the water tank assembly. The soap says steam cleaning soap so I guess theyre cheating.

BISSELL STEAM SHOT SPRAYING WATER FULL

If the spray function has quit working on the carpet cleaner, check to make sure there is a full tank of water. My Bissell so-called carpet steam cleaner just squirts out warm water spray. The cleaner will emit a constant stream of steam as long as there is water in the tank.ĭisinfect an area of the floor by holding the steamer over it for approximately eight seconds. Repair a Bissell steam cleaner that has stopped spraying. Steam will start coming out of the cleaner when it is ready for use.Ĭlean your floor by pushing and pulling the steamer over the floor as if you were using a standard hard floor cleaner. Press the power button to preheat the steamer, which takes approximately three minutes.

Plug the power cord into an electrical outlet and set the steamer on the preheating tray.

Bissell steam shot spraying water